MS 152/7 P

MS 152/7 P

Introduction
The MS 152 is a shell and tube heat exchanger with removable tube bundle, so it can be inspected and cleaned easily.
It is available with a standard copper tube bundle for fresh water, in stainless steel for harsher fluids, and in CuNi for marine use.

What the size code means
In the Sesino range the size number refers to the shell diameter. Two tube versions are available on this size: /7 (7 mm tubes) and /10 (10 mm tubes).

Materials and construction
• Standard materials: copper tube bundle, for fresh water (standard application)
• Stainless steel tube bundle, AISI 304 or AISI 316L: contaminated water, corrosive fluids and gases, or generally fluids more aggressive than fresh water
• CuNi tube bundle: marine application, with seawater
• Tube bundle: always removable

Key features

• Removable tube bundle, always, for easy inspection and cleaning
• /7 version: 7 mm tubes. More tubes fit in the same space, so it exchanges more heat.
• /10 version: 10 mm tubes. It exchanges less heat and suits applications where the water is not very clean.
• Standard working and test pressures are 12/15 bar; higher pressures are available on request.
Typical applications
• Standard industrial cooling and heating circuits with fresh water (copper tube bundle)
• Contaminated or aggressive water, corrosive fluids and gases (stainless steel AISI 304 or AISI 316L)
• Marine applications with seawater (CuNi)

FAQ
Which materials are available for the MS 152?
Standard materials (copper tube bundle) suit the standard application with fresh water. Stainless steel tube bundle (AISI 304 or AISI 316L) is for contaminated water or fluids more aggressive than fresh water. CuNi tube bundle is for marine applications.
Is the tube bundle removable?
Yes. The bundle is always removable.
What is the difference between /7 and /10?
/7 has 7 mm tubes: more tubes in the same space, so higher heat exchange. /10 has 10 mm tubes: lower heat exchange, better when the water is not very clean.
What pressures are available?
Standard working and test pressures are 12/15 bar. Higher pressures are available on request.

Tell us your fluids, flow rates and operating pressure, and we will configure the right MS 152 for you.

Oil FlowPower (DT 25°C)in/out oil sidein/out water side
l/min kWGASGAS
40-5004,5 - 1303/4" - 2"1" - 2"

THIS IS AN EPIC
OVER 10O-YEAR-LONG HISTORY

I wrote these words in order to briefly summarize our over 100-yearlong history and share it with my current and past collaborators. While I did not personally experience the oldest parts of the story, from the beginning up to the 1950s, it was related to me orally or in writing by my father, Santo, and by uncle, Alfredo. The history from the late 1960s to the present, however, I have witnessed firsthand.

Gianluigi Sesino, President